How To Make Sandblasted Signs

Part I of Essay
I am going to tell you how you can make a sandblasted sign. The only necessary tools you need are: bass wood, or red wood, rubber masking, spray glue, exacto knife, sand paper, paint (which most of these items you can find at your local hardware store). Also you need to ....

Part II of Essay
.... glue to the rubber masking. Once you have sprayed the glue (in a well ventilated area) to the masking you should wait for about 2 minutes for the adhesive to dry, and begin to cut out your design you have chosen. This is a very time consuming task so it is best to take your time. This is the time to start cutting on your masking. It is best to leave about one half of an inch around the outside edge of the board. Use your exacto knife to cut the masking. Make sure to center your design and that it is suitably sized to your board. I ....